This is the PCB board (circuit board) of a HGST / Hitachi 2.5'' Hard Drive
ESSENTIAL INFORMATION |
Item Information |
The Process |
Model: HTS541075A9E680
P/N: 0J26312
MLC: DA4863
Firmware: Please read description to the right -->
Capacity: 750GB
Sticker #: 0J14451
PCB #: 0A90351
Main chip: 88i9305
|
-
Locate the number imprinted onto your PCB board (circled in our picture), it should say 0A90351.
-
The number on the sticker on your circuit board should say 0J14451.
-
Verify the number on the largest square chip on your board is: 88i9305.
-
If the above are matching, then we can make a clone of your board. We will need you to mail the dead circuit board to us.
To make the clone, we will need you to fill this form, then ship your DAMAGED PCB (circuit board) to us. We will copy the information from your PCB onto our PCB, then ship the working cloned PCB back to you. See detailed procedures here.
If you prefer to do this yourself (transplant an 8 pin ROM chip), just let us know by emailing us or mention it in the comments during checkout.
This process is ALWAYS necessary to ensure compatibility for this model: your board contains UNIQUE information about your hard drive. You can find a more detailed explanation here.
| |
When to buy this item: |
We recommend buying this item when you are sure it is the PCB. For example, if there was a power surge, or some components are obviously burnt, or the wrong power adapter was used to power up the drive. If the drive will not spin up at all, and wasn't dropped, chances of success with replacing the PCB are quite good.
There are no refunds with this purchase, so if you would like to describe the specific symptoms to us, please Contact us through our online form or at info@pcbsolution.com, we will try our best to reply within 12 hours. | |
Item Includes: circuit board, firmware transfer and installation instruction sheet |
ADDITIONAL INFORMATION
What this board is supposed to do for you:
If your hard drive has stopped working, chances are you have some important data stored on it. Sometimes the hard drive failure is caused by a circuit board failure. This product is made to be an identical and functional replacement for your circuit board, therefore repairing your hard drive and saving you expensive data recovery charges. Please note that hard drive failures are NOT always caused by circuit board failure, this board is not guaranteed to fix your hard drive.
Please Note:
1. This is just the hard drive PCB board, not the whole hard drive.
2. All hard drive PCB boards have been fully tested before shipment, there is no refund policy, but we offer an exchange if the board has obviously been damaged during shipping.
3. If you bought the wrong hard drive PCB board by accident, please inform us a.s.a.p.
4. To ensure compatibility, please follow the steps listed above carefully.
Our testing procedure and FAQs:
Click here to find out about our testing procedure and general FAQs
Shipping Policy:
Click here for detailed information
Closing Comments
Thank you very much for taking the time to look at our site. Remember, if you have ANY questions or concerns, please feel free to email us directly at info@onepcbsolution.com. We reply 99.99% of all emails/messages within 12 hours of receiving them. Thank you again for looking at our site and best of luck repairing your hard drive!