Maxtor DiamondMax 10 200 200GB SATA 6L200SO BACE1G20 040121300 Hard Drive Donor PCB Board

Maxtor DiamondMax 10 200 200GB SATA 6L200SO BACE1G20 040121300 Hard Drive Donor PCB Board
Item# maxtor-diamondmax-10-sata-1300-053
$39.99
This item is currently out of stock!

Product Description

This is the PCB board (circuit board) of a Maxtor DiamondMax 10 SATA Hard Drive

ESSENTIAL INFORMATION

Item Information

How to Use this Information

Model: 6L200SO
Code: BACE1G20
Capacity: 200GB
Main Chip #: 040121300

  1. Locate the largest chip on your PCB board. (Circled red in the picture)
  2. On this chip, there should be a row of numbers that says 040121300.
  3. On the label side of the drive, near the bottom left hand side, there should be a line that says "Code: BACE1G20".
  4. The model number is located at the top right of the label, it should say "6L200SO".
  5. If you have gotten to this step, then this PCB board is a match for your drive.
What to do if PCB is NOT a match for your drive / if you are not sure:

Option 1: Contact us through our online form by clicking here, we will try our best to locate the correct PCB for you, and reply within 12 hours.
Option 2: Try using our interactive online guide by clicking here.

Item Includes: circuit board, torx screwdriver and installation instruction sheet

ADDITIONAL INFORMATION

What this board is supposed to do for you:
If your hard drive has stopped working, chances are you have some important data stored on it. Sometimes the hard drive failure is caused by a circuit board failure. This product is made to be an identical and functional replacement for your circuit board, therefore repairing your hard drive and saving you expensive data recovery charges. Please note that hard drive failures are NOT always caused by circuit board failure, this board is not guaranteed to fix your hard drive.


Please Note:
1. This is just the board, not the whole hard drive.
2. All boards have been fully tested before shipment, there is no refund policy, but we offer an exchange if the board has obviously been damaged during shipping.
3. If you bought the wrong board by accident, please inform us a.s.a.p.
4. To ensure compatibility, please follow the steps listed above carefully.


Our testing procedure and FAQs:
Click here to find out about our testing procedure and general FAQs


Shipping Policy:
Click here for detailed information


Closing Comments

Thank you very much for taking the time to look at our site. Remember, if you have ANY questions or concerns, please feel free to email us directly at info@onepcbsolution.com. We reply 99.99% of all emails/messages within 12 hours of receiving them. Thank you again for looking at our site and best of luck repairing your hard drive!