Seagate Barracuda 7200.11 750GB ST3750630AS 9BX146-621 HP24 TK 100466824 Hard Drive Donor PCB without Firmware Transfer

Seagate Barracuda 7200.11 750GB ST3750630AS 9BX146-621 HP24 TK 100466824 Hard Drive Donor PCB without Firmware Transfer
Item# 729278775
$49.99

Product Description

This is the PCB board (circuit board) of a Seagate Barracuda 7200.11 Hard Drive

ESSENTIAL INFORMATION

Item Information

The Process

Model: ST3750630AS
P/N: 9BX146-621
Firmware: HP24 (Incompatible, read more on right -->)
Site Code: TK
Capacity: 750GB
Board #: 100466824

Not a Match? Try our PCB Finder

This item is NOT compatible with your hard drive right now. The reason is every single board of this model has a unique firmware, despite what it may say on the drive label.

This item will be compatible after a chip transplant involving difficult SOLDERING, do not purchase this item unless you can solder, and more importantly, de-solder.

We can make the boards compatible for you and take care of the soldering, but we need you to ship the dead board to us. If you would like us to do the soldering, do not purchase this item, but purchase the item in this link.

When to buy this item:

A common problem with Seagate Barracuda 7200.11 drives is that it would suddenly stop being recognized by the computer, or be recognized as 0MBs. Normally, there is a decent chance that it could be the PCB at fault, but with 7200.11 drives, it usually is NOT the PCB, but a firmware problem instead. A data recovery professional is a better choice.

We recommend buying this item when you are sure it is the PCB. For example, if there was a power surge, or some components are obviously burnt, or the wrong power adapter was used to power up the drive. If the drive will not spin up at all, and wasn't dropped, chances of success with replacing the PCB are quite good.

There are no refunds with this purchase, so if you would like to describe the specific symptoms to us, please Contact us through our online form or at info@pcbsolution.com, we will try our best to reply within 12 hours.

Item Includes: circuit board, firmware transfer and installation instruction sheet

ADDITIONAL INFORMATION

What this board is supposed to do for you:
If your hard drive has stopped working, chances are you have some important data stored on it. Sometimes the hard drive failure is caused by a circuit board failure. This product is made to be an identical and functional replacement for your circuit board, therefore repairing your hard drive and saving you expensive data recovery charges. Please note that hard drive failures are NOT always caused by circuit board failure, this board is not guaranteed to fix your hard drive.


Please Note:
1. This is just the hard drive PCB board, not the whole hard drive.
2. All hard drive PCB boards have been fully tested before shipment, there is no refund policy, but we offer an exchange if the board has obviously been damaged during shipping.
3. If you bought the wrong hard drive PCB board by accident, please inform us a.s.a.p.
4. To ensure compatibility, please follow the steps listed above carefully.


Our testing procedure and FAQs:
Click here to find out about our testing procedure and general FAQs


Shipping Policy:
Click here for detailed information


Closing Comments

Thank you very much for taking the time to look at our site. Remember, if you have ANY questions or concerns, please feel free to email us directly at info@onepcbsolution.com. We reply 99.99% of all emails/messages within 12 hours of receiving them. Thank you again for looking at our site and best of luck repairing your hard drive!